QOC Solutions offers manual quick opening closures with tooth as well as automatic. This type of QOC gets activated through the rotation of a system of teeth which allows the fast opening. The manual rotation uses a rack system, while the automatic one uses a hydraulic piston and pump system.
The recommended sizes for our quick opening closures with tooth go from DN 6’’ to DN 46’’, and the specially recommended rating is the ANSI 150 one, even if the typology can be applied to rating ANSI 600.
| Product Information | |
| QOC Nominal Size | From 6″ to 46″ |
| QOC Design Code | ASME VIII Div. 1 / Div. 2 / EN 13445 |
| QOC Design Pressure Rating | Up to ANSI 600 |
| QOC Design Temperature (min/max) | -46°C / +350°C |
| Qoc Orientation | Horizontal/Vertical |
| Gasket Seal | Lip seal |
| Design Conditions | |
| Design Code ASME VIII Div. 1 | Yes |
| Code stamped |
|
| Vassel Wall Thickness | Acc. to the vessel |
| Vessel PWHT |
 |
| NACE Compliance (MR0175/ISO15156) |
|
| Principal Materials | |
| Hub Material | Carbon steel/Stainless Steel/Duplex/Super Duplex |
| Door Material | Carbon steel/Stainless Steel/Duplex/Super Duplex |
| Gasket Seal | NBR/HNBR/VITON/KALREZ |
| Hinge/Davit Material | Carbon Steel / Stainless Steel |
| Pressure Warning Screw Material | Stainless Steel |
| Pressure Warning Screw Seal Material | HNBR |
| Certification | |
| Material Certification | Acc. to EN 10204 2.2/ 3.1/3.2 |
| Non-Destructive Testing | |
| M.P.I. On Weld End Preparation |
|
| Dye Penetrant onWeld End Preparation |
|
| Ultrasonic Examination | Yes |
| Other Requirements | |
| Inspection Requirements |
|
| ASME U/U2 – Stamp Partial |
|
| CE Marking |
|
| Finish rough machined | |
| Finish (std) | Sandblasted and coated with zinc rich epoxy primer |
| Weld Overlay Material |
|
| Nickel plating |
|
| Final painting according to specification |
|
| Cold galvanizing | N.A. |
| Teflon coating | N.A. |
| Mechanical Key Interlock |
|